Why would a pilot light go out on a water heater?

Some of the most common reasons that water heater pilot lights go out include: A faulty thermocouple. Over time, thermocouples can begin to malfunction and shut off the gas supply to the pilot light even if it’s burning properly. A bent or dirty thermocouple.

How do I get my pilot light back on?

Turn the valve to the “pilot” position. Press and hold the reset button. If the reset button fails, ignite the lighter. Hold down the reset button and bring a grill lighter or long match to the pilot light valve until the pilot ignites.

What to do when pilot light goes out on Rheem water heater?

If the pilot light goes out when you release the red button, repeat steps four and five. If you smell gas at any time while you are lighting your Rheem water-heater pilot light, leave your home immediately and call your gas provider’s emergency phone number from another location.

What does Rheem stand for on a water heater?

Rheem (” Company ” or ” We “) respect your privacy and are committed to protecting it through our compliance with this policy.

What do you need to know about the Rheem policy?

This policy describes the types of information we may collect from you or that you may provide when you visit the website (our ” Website “) and our practices for collecting, using, maintaining, protecting, and disclosing that information. On this Website. In email, text, and other electronic messages between you and this Website.

Where is the pilot light on a Rheem hot water heater?

It is a small, bulb-shaped device located near the pilot aperture. When it is working properly, it generates a small electrical current to keep the gas valve opened when heated by the flame. A common problem with Rheem water heaters is a loose thermocouple that falls slightly out of position.

Do you need to relight a gas pilot light?

You might have purposely blown out the pilot light in summer to save energy, and now you need to relight it as part of your winter home maintenance routine. Regardless of the reason, your gas water heater or furnace can’t turn on if the pilot light is out. Fortunately, relighting a pilot light is easy.

How do you relight a furnace pilot light?

Wait five to 10 minutes for any residual gas to clear out of the furnace. Turn the gas control knob or knobs to the ON position. Replace the access panel. Turn the electrical power to the furnace back on. Set your thermostat to your desired temperature. After a few seconds, the pilot will light up, igniting the furnace’s burners.

What’s the best way to light your RV pilot light?

The video above gives a quick, simple walkthrough for lighting your RV’s pilot light. Plus, you’ll learn when to leave it on, and when to turn it off. Want to get the most out of your RV?