Why is the temperature sensor on my triangle tube not working?

A short circuit has been detected in the system temperature sensor circuit. An open circuit has been detected in the system temperature sensor circuit. Display memory error. Supply sensor reading is invalid. An open circuit has been detected in the outdoor temperature sensor circuit. Cascade configuration has changed.

When to contact triangle tube for technical support?

If problem is not resolved, contact Triangle Tube Technical Support for additional assistance. Check to see if a sensor is far out of calibration or moving in a direction un-compatible with the process that the controller is presently running. With the unit off for at least 1 hour, go to the Info mode of the boiler. Look at steps 1, 2 and 5.

What is the boiler code for a triangletube Challenger?

TriangleTube CHALLENGER CC 85 boiler error codes Display Error Description Possible Solution 10, 11,12, 13,14 – CH Supply Sensor fault S1 • Check for proper flow direction • Replace S1 • E10 open sensor •E11 Short sensor

What should the resistance of a triangle tube be?

If the fault will not reset, then unplug the gas valve and reset again. If the unit will not reset, replace the control module. Be sure to test the resistance of the gas valve, these are 120 volt gas valves and should have approximately 375 ohm resistance on one coil, and 717 ohms on a second coil.

How to follow the prestige Troubleshooting Guide Guide?

REMEMBER Follow the Troubleshooting Guide step by step, always double checking your results. Skipping steps or not complet – ing steps can lead to wrong conclusions, repeated visits to the job site, unhappy customers and unnecessary warran – ty claims. S.;?2,270 T29< *7- I7<=;>,=287

If problem is not resolved, contact Triangle Tube Technical Support for additional assistance. Check to see if a sensor is far out of calibration or moving in a direction un-compatible with the process that the controller is presently running. With the unit off for at least 1 hour, go to the Info mode of the boiler. Look at steps 1, 2 and 5.

A short circuit has been detected in the system temperature sensor circuit. An open circuit has been detected in the system temperature sensor circuit. Display memory error. Supply sensor reading is invalid. An open circuit has been detected in the outdoor temperature sensor circuit. Cascade configuration has changed.