Why is my sink water hot but my shower cold?

If you’re getting hot water everywhere but your shower, it could be that your anti-scald device is set at too high a limit. Anti-scald devices (also called a “hot limit stop” or “rotational limit stop”) are safety features that most faucets have.

What is the thermostatic mixing valve for a Kohler shower?

The K-2973 and K-2976 thermostatic mixing valves contain a single volume control/shut-off valve for controlling the water flow through the shower outlet. When plumbing to the valve’s bath outlet, you must install a separate volume control shut-off valve (K-2974 or K-2977) downstream from the bath outlet. 1205551-2-D 4 Kohler Co.

What should the water temp be in a Kohler shower?

High water temperature can cause severe burns. Set the water temperature at or below 120°F (49°C) following the adjustment procedure. NOTICE:Use only 1/2″ (5/8″ OD) copper pipe (type L or M) between the valve and bath spout. Using other materials may cause back pressure and result in water flowing from the showerhead and bath spout at the same time.

What’s the difference between hot and cold Kohler valves?

Although Kohler ceramic valve cartridges are available in hot (which means the water turns off by turning the handle clockwise) and cold (the water turns off counterclockwise), the only difference between the two is the way the valves turn. However, if you mistakenly have a “hot” when you need a “cold,” the valves can be reversed.

What should the PSI be on a Kohler rite temp valve?

If only cold or hot water is applied, the diaphragm inside of the valve will block the outlet and prevent any water from flowing to the outlet. Kohler Rite-Temp valves require a minimum of 45 PSI on both the hot and cold supplies.

The K-2973 and K-2976 thermostatic mixing valves contain a single volume control/shut-off valve for controlling the water flow through the shower outlet. When plumbing to the valve’s bath outlet, you must install a separate volume control shut-off valve (K-2974 or K-2977) downstream from the bath outlet. 1205551-2-D 4 Kohler Co.

High water temperature can cause severe burns. Set the water temperature at or below 120°F (49°C) following the adjustment procedure. NOTICE:Use only 1/2″ (5/8″ OD) copper pipe (type L or M) between the valve and bath spout. Using other materials may cause back pressure and result in water flowing from the showerhead and bath spout at the same time.

Although Kohler ceramic valve cartridges are available in hot (which means the water turns off by turning the handle clockwise) and cold (the water turns off counterclockwise), the only difference between the two is the way the valves turn. However, if you mistakenly have a “hot” when you need a “cold,” the valves can be reversed.

What do you need to know about Kohler rite temp valves?

The Installation Instructions require the removal of the pressure balancing unit and mixer cap prior to soldering to prevent damage to the internal components of the valve. Kohler Rite-Temp valves feature a mixer cap that is designed for a hot water inlet from the right and cold water from the left.