Why is my gas Califont not working?

If you have a natural or propane gas water heater, chances are the pilot has gone out. If the pilot doesn’t relight, if it goes out right after lighting or if it goes out repeatedly, by far the most common cause is a bad thermocouple.

Is the Rinnai Infinity 26 a hot water heater?

It is important to note that usually, tank less water heaters like the Rinnai Infinity 26, do not provide hot water straight away, unless it has been installed with a recirculation pump or a buffer tank. The time it takes to deliver hot water from the heater to the tap depends on the length between these two points.

What should I do if my Infinity 26 water heater is not working?

Before calling a technician to come and source your fault and fix it, there are some steps that you can take as the owner of an Infinity 26 to troubleshoot the fault first. First – check the power supply.

Why is the Infinity 26 not hot enough?

The thing with instant units is that they need to lift the water temperature as its flowing through the unit. In winter the starting water temperature is lower and the desired output temperature is typically higher. i.e. lower performance but this shouldn’t really be an issue for the Infinity 26. They are the green insulated pipes.

How to install a Rinnai hot water tap?

Make sure that the hot water tap is turned off tightly. CONSIDER….. Installing child proof tap covers or child resistant taps (both approaches will prevent a small hand being able to turn on the tap). Setting your appliance at a maximum temperature of 50°C (Contact Rinnai Australia). NEVER….. Leave a toddler in the care of another child.

It is important to note that usually, tank less water heaters like the Rinnai Infinity 26, do not provide hot water straight away, unless it has been installed with a recirculation pump or a buffer tank. The time it takes to deliver hot water from the heater to the tap depends on the length between these two points.

How does a Rinnai Water controller extinguish a fire?

Once water is flowing through the appliance the burner will be ignited by electronic ignition. When the hot water tap is closed and water flowing through the appliance has stopped the burner flame will extinguish. RINNAI WATER CONTROLLERS NOTE

How can I tell if my Rinnai Water Heater is failing?

Check for any visible flame through the window box of the heater. If you see any flame in the burner box, you can assume it is for flame failure. However, if you do not see any flame, it must be of electrical failure. If there is an electrical fault, there may be a short circuit within the PC.

What does code 16 on Rinnai Water Heater mean?

Code 16 is directly a warning displayed on the screen. It means over temperature warning and the heater has automatically shut down to protect itself from damage. You need to start with the air filter and know if it is clean. Look for any type of blockage or clogging in the filter.