Why is my Craftsman water pump not working?

Craftsman water pumps use powerful and rugged drive motors to turn the impellers in their water pumps. When your Craftsman water pump isn’t moving water as it should, rely on Sears PartsDirect to have the repair parts you need to fix the pump. Pump check valve.

What kind of parts do I need for a craftsman water pump?

Sears PartsDirect is a leading supplier of repair and replacement parts for Craftsman water pumps. Craftsman water pumps use powerful and rugged drive motors to turn the impellers in their water pumps. When your Craftsman water pump isn’t moving water as it should, rely on Sears PartsDirect to have the repair parts you need to fix the pump.

How do I Turn On my Craftsman power washer?

Turn the water supply on. This will start the flow of water into your washer. Press and hold the trigger on your spray gun. This will run water through the system, removing any air or debris. Continue to do this until the water flows freely.

Is it better to replace an old pump in a pressure washer?

It is often better to replace your old pump with a new (better quality) pump. This will result in a better Pressure Washer for less money than purchasing a new Pressure Washer with an inferior pump.

How big is a craftsman shallow well jet pump?

1/2 hp Hydro-Glass®, Craftsman Professional shallow well water pump capable of pumping up to 8.2 [LG_GPM]. Performance is based on depth to water of 20 ft. or less and a 40/60 pressure rating. Built-in Check Valve – prevents pumped water from returning to source Built-in shallow well jet – eliminates additional purchase

How to replace a pressure washer water pump?

Instructions 1 Disconnect the spark plug wire. Disconnect the spark plug wire from the spark plug. 2 Disconnect the hoses attached to the pump. Remove the inlet water hose from the pump, if attached. 3 Remove the pump. 4 Prepare the new pump for installation. 5 Install the new pump. 6 Reconnect the hoses on the pump.

How do you replace a pump on a Briggs and Stratton pressure washer?

This procedure shows Craftsman pressure washer pump replacement but the same basic process works for pump replacement on Briggs & Stratton, Snapper, Troybilt, Husqvarna and Generac pressure washers. 01. Disconnect the spark plug wire from the spark plug.

How do you install an O ring on a craftsman pressure washer?

Use these steps to install the O-ring kit in Craftsman, Generac, Briggs & Stratton, Snapper, Husqvarna and Troybilt pressure washers. 01. Disconnect the spark plug wire from the spark plug. 02. Sort the O-rings in the kit by size. Tip: You may not need all of the O-rings included in the kit. 03.