Why does my Whirlpool Duet washer fill with water?

If your washer continues to fill during a cycle, the water inlet valve could be at fault. If the washer continues to fill, then the water inlet valve is defective. If the washer stops filling, then the problem is related to the electrical circuit that controls the valve.

Why is my Whirlpool washer not draining water?

When the drain hose is kinked, bent, blocked or clogged, the washer won’t drain. To handle the blockage problem, disconnect the drain hose and give it a good cleaning. Then, reconnect the drain hose to the machine, turn the electricity back on and run the rinse/spin cycle to see if the washer is draining properly.

What to do if your Whirlpool duet washer is not working?

Hoverer, the clean washer cycle is there for a reason! Your washer can get extremely nasty inside in places you can’t see. Try leaving the door open a crack when the washer is not in use and make sure to use the Clean Washer cycle from time to time. Unplug the washer for 30 seconds to attempt to reset the Duet washer control.

Why is my Whirlpool duet washing machine making a grinding noise?

Try manually turning the washer’s inner drum and listen for anything that may be stuck between the washer’s inner and outer tubs. If you are hearing an even grinding noise coming from the back of the washer, you may have a bad main bearing. This is a fairly common problem with front load washing machines.

What does F21 mean on Whirlpool duet washer?

If your Duet washer has an F21 error code (long drain) you may want to skip passed all the fill steps to step C06 (to test the drain pump.) After the door locks (C00) You can skip forward to test the drain pump by pressing the same button you chose to start the diagnostics.

How can I Reset my duet front load washer?

Unplug the washer for 30 seconds to attempt to reset the Duet washer control. Check the Duet door lock. (Duet Door Lock Check) Unplug the washer for 30 seconds to attempt to reset the Duet washer control.

Hoverer, the clean washer cycle is there for a reason! Your washer can get extremely nasty inside in places you can’t see. Try leaving the door open a crack when the washer is not in use and make sure to use the Clean Washer cycle from time to time. Unplug the washer for 30 seconds to attempt to reset the Duet washer control.

Where is the tab on the Whirlpool duet washer?

Located on the bottom of the door switch/lock unit is a tear-drop shaped tab. Gently pull the tab down about a 1/4-inch or until a click is heard. The door can then be opened. If the problem happens again, the door lock/latch should be replaced.

How can I reset the duet washer control?

Unplug the washer for 30 seconds to attempt to reset the Duet washer control. Check the power supply at the wall with some other device. If the wall plug has power… Check power at the control.

If your Duet washer has an F21 error code (long drain) you may want to skip passed all the fill steps to step C06 (to test the drain pump.) After the door locks (C00) You can skip forward to test the drain pump by pressing the same button you chose to start the diagnostics.