Why does my water softener say error?
Andrew Davis Why does my water softener say error?
If a malfunction occurs, an error code will appear in the display which indicates an electrical problem in the timer, the motor, the wiring, etc. If you just installed your water softener, it is possible that you have a loose or disconnected wiring in the control.
What does SERV mean on water softener?
water softening system
When the water softening system is providing soft water, it is called “service.” During service, hard water flows from the house main water pipe into the water softening system.
What should my water softener hardness be set at?
Your water softener hardness setting should be set to the amount of hardness in your water plus 4 for every part per million of dissolved iron in your water. On an older water softener, you may need to set your hardness slightly higher as the resin becomes less efficient.
What does err 1 mean on a GE Water Softener?
When the Err 1 error code appears in your GE SmartWater water softener’s display, there has been an electronics failure. As a result, the control settings must be reprogrammed. Pressing any key on the display will load the default settings.
What happens if there is an error code on a water softener?
If there is an error code detected, the blue indicator light will flash 4 times every second and the display will flash ERR. An alarm will beep every 30 seconds (from 8:00am to 8:30pm) to signal that the softener requires service. The alarm can be turned off by pressing any button but the blue indicator light and display will flash.
Can a GE Water Softener go out of service?
However, if the valve cam gear rotates into the out-of-service position, the control valve must activate the motor so the cam gear can be moved to the proper position. A GE SmartWater water softener may also experience an improper regeneration start if there is an issue with the softener’s motor.
Why is the timer not working on my water softener?
The timer is the control board you use to program the water softener. If the timer isn’t accepting commands when you push the buttons or if the display won’t power up, replace the timer. The rotor position switch detects the position of the valve rotor.
When the Err 1 error code appears in your GE SmartWater water softener’s display, there has been an electronics failure. As a result, the control settings must be reprogrammed. Pressing any key on the display will load the default settings.
If there is an error code detected, the blue indicator light will flash 4 times every second and the display will flash ERR. An alarm will beep every 30 seconds (from 8:00am to 8:30pm) to signal that the softener requires service. The alarm can be turned off by pressing any button but the blue indicator light and display will flash.
However, if the valve cam gear rotates into the out-of-service position, the control valve must activate the motor so the cam gear can be moved to the proper position. A GE SmartWater water softener may also experience an improper regeneration start if there is an issue with the softener’s motor.
The timer is the control board you use to program the water softener. If the timer isn’t accepting commands when you push the buttons or if the display won’t power up, replace the timer. The rotor position switch detects the position of the valve rotor.
