Why does my hot tub say error?
Andrew Thornton Why does my hot tub say error?
Some of the most common hot tub error codes are FLO, FL1 or FL2, and are picked up by flow or pressure switches. The most common causes for this are a dirty or damaged filter, low water levels, air in the pipework or a faulty pump or sensor..
What does F8 mean on my hot tub?
The F8 is usually indicating Filter=8 hours of filtration. Change modes to standard, and change filtration to desired level.
What does PR mean on a hot tub display?
The Big List of Spa and Hot Tub Error Codes
| CODE | ERROR CODE DESCRIPTION |
|---|---|
| Pr | Priming – pump is starting; system message, not an error |
| Prh | High limit sensor failure |
| Prr | Temperature sensors alarm |
| PS | Water sensor/pressure switch fault |
What to do if your hot tub has an error code?
If however you have the fault then the first thing to do is shut the spa down, do not empty, remove the filter and make sure all the jets are open (as best you can). Then re-start the hot tub, if the error code goes away, the problem was either a dirty filter (clean or replace) or too many jets were closed off.
When do I need to reset my hot tub control panel?
If your hot tub control panel isn’t working then when it can be really frustrating. Having said that, sometimes all you need to do is a simple reset on your hot tub control panel to clear the problem and to get it back into action.
What does blinking red light on hot tub control panel mean?
Blinking Red Light. A blinking red light on the control panel may indicate it needs to be reset. For most models you will turn off the power to the spa for a minute or two and then turn it back on. Turn on the lower amp breaker first if you have a hot tub powered by 240 volts.
How to know if your hot tub is overheating?
Hot Tub Topside Keypad Error Codes & Messages 1 Balboa. OH = Sensors reading 112-118° F. OHH = Overheat. Spa has shut down. One sensor has detected 118° F at heater. 2 Brett Aqualine 3 CTI. OH = Overheating, water over 112° F. System will restart when temp. drops. HL = High limit switch tripped. 4 EasyPak 5 Gecko 6 Hercules 7 Hurricane 8 Hydro-Quip
Is there an error code on my hot tub?
Below is a list of common error codes from the top manufacturers of control equipment for hot tubs. Note: The control system brand name is usually different from the hot tub brand name. You can often determine the make of the control system by looking inside the spa’s equipment area.
If your hot tub control panel isn’t working then when it can be really frustrating. Having said that, sometimes all you need to do is a simple reset on your hot tub control panel to clear the problem and to get it back into action.
Blinking Red Light. A blinking red light on the control panel may indicate it needs to be reset. For most models you will turn off the power to the spa for a minute or two and then turn it back on. Turn on the lower amp breaker first if you have a hot tub powered by 240 volts.
What to do if hot tub pressure switch is mis-calibrated?
If you don’t confirm water is moving in the hot tub and through the heater do not proceed with the next step as in doing so may burn out the heating element. To check to see if the pressure switch is defective or mis-calibrated, please do the following: Power down the circuit board.
