Why do I need to change the spindle on my shower?

Some older showers use a spindle instead of cartridges or compression seals to adjust the rate of water flow. Usually, spindle shower faucets are two-handle faucets without a diverter. Over time spindles wear down, requiring replacement.

Why does my Moen shower have no water?

If your Moen shower valve has no water, it’s most likely because hot and cold water may not be supplied to the valve. This can happen because of improper use or there is an obstruction in the showerhead/spout. If you have external shut-off valves, verify they are opened all the way.

What are the signs of a bad shower valve?

Below are some of the signs you could have a bad shower valve that needs to be replaced: Leaks or drips coming from the spout. Difficulty turning the shower handle, which worsens over time. Hot water suddenly starting to run hotter or water becoming too cold.

Is there a cut off valve behind the shower wall?

There are cut-off valves for the hot and cold water behind the shower wall. The shower wall usually has an access panel in the adjoining room. Place a towel or sheet over the shower drain to prevent losing small parts down the drain and to protect the shower floor.

Why does my shower spindle not turn on?

If you’re wondering what this spindle does, let me tell you. The two rubber washers that are mounted on this thing stop any leaks that might exist if they weren’t there. Also, it controls the balance between hot and cold water. Finally, if your shower valve feel very tight when you try to turn it, this is probably the culprit.

Where can I get a new shower spindle?

Replacement spindles are available at plumbing-supply houses and from the faucet manufacturer. Shut off the water supply to the shower. There are cut-off valves for the hot and cold water behind the shower wall. The shower wall usually has an access panel in the adjoining room.

What’s the stem spindle for a Symmons shower valve?

I offer step by step instructions for rebuilding a Symmons shower valve. The part I was waiting for is called a Stem Cartridge Spindle For Symmons TA-10 Temptrol and it looks like this: To be honest with you, I think I could have gotten away with replacing just this one part to stop the leak.

How to re-calibrate a Moen shower valve?

To re-calibrate the valve, it is necessary to gain access to the spindle (located behind the temperature extension near the top of the valve). Turn the temperature extension counterclockwise until it stops. Loosen and remove the screw in the center of the temperature extension by turning it counterclockwise.