Where is refrigerator water supply valve?

If your refrigerator has a water and ice dispenser feature, or even just an installed ice maker, a water supply valve is required to control the water coming into the appliance. The supply valve is usually located at the bottom rear of the refrigerator behind an access panel.

Do you need a shut off valve behind fridge?

There’s no need to shut off the water to the entire kitchen, which can be an inconvenience for you and the family. Instead, control the flow to the fridge by shutting off the water at the site prior to a repair or the installation of a new replacement fridge.

How much does it cost to replace a water valve on a refrigerator?

Cost to Repair Ice Maker in Refrigerator The most common repair is replacing the water inlet valve, which costs between $150 and $200 to fix. Most homeowners pay $180 for ice maker repairs.

Can a refrigerator be used without a water line?

You don’t need to hook it up if you don’t want ice and water, the fridge will work fine without it. No, you do not have to install the water line. The ice maker itself doesn’t take up too much space in the freezer, so you could just turn it off and pretend it’s not there.

What kind of valve do you need for a refrigerator water line?

Self-tap saddle valves are often the type of valve included in supply line kits. When using a self-tap saddle valve, attach the valve to the pipe, but do not pierce the pipe until the water line has been connected to the back of the fridge. When using a tee stop valve, you will have to remove a section of the sink’s water supply pipe.

How do you connect a water supply to a refrigerator?

Connect the end of the tube to the 1/4-inch water supply fitting on the refrigerator. Tighten the connection just slightly more than hand-tight, using pliers. Now turn on the faucet shutoff valve under the sink and check for leaks at the Adapt-a-Tee connections.

How big of an outlet do you need for a refrigerator water line?

If your sink has a shut-off valve, you can tap it using a tee fitting . The tee fitting should fit the threads of your valve, while the third outlet should have an outside diameter of 1/4-inch for the refrigerator water line.

Where is the water shut off valve on a refrigerator?

While the location of the water shut-off valve varies from fridge model to fridge model, and home to home, there are a few specific places you are likely to find it: Hidden in a box or metal guard at the water source. Located near the cold water supply at the bottom of the kitchen sink. In the basement. In a crawl space.

How do you replace a water valve in a refrigerator?

Connect the two wire harnesses to the terminals on the side of the replacement ice and water valve. Line up the screw holes in the valve bracket with the screw holes in the body of the refrigerator. Secure the replacement valve with the hex-head screws you removed from the original valve.

How do you hook up water to a refrigerator?

Usually behind where a refrigerator is installed, there will be a water valve that you can use to hook cold water to your fridge. If there is no water valve behind your fridge, you will have to run a water line to the closest cold water pipe to get your refrigerator access to water.

How do you install a refrigerator water supply line?

How to Install a Refrigerator Water Line Step 1 – Locate the Closest Cold-Water Supply Line Step 2 – Drill a Hole for the Water Line Step 3 – Connect the Water Line to the Refrigerator Step 4 – Connect the Water Line to a Water Supply

How do you turn off the water line in a refrigerator?

Turn the cold water supply valve on beneath the sink. Let 1 or 2 gallons of water run through the new line to remove the air. Turn off the supply line. Slip the remaining compression nut and ferrule over the refrigerator end of the new water line.