When to contact triangle tube for technical support?

If problem is not resolved, contact Triangle Tube Technical Support for additional assistance. Check to see if a sensor is far out of calibration or moving in a direction un-compatible with the process that the controller is presently running. With the unit off for at least 1 hour, go to the Info mode of the boiler. Look at steps 1, 2 and 5.

How long does it take to install a triangle tube?

• When receiving the SMART unit, any claims for damage or shortage in shipment must be filed immediately against the transportation company by the consignee. • Customer must register unit within sixty (60) days of installation in order to gain warranty coverage. See Warranty Card for details.

What do you need to know about triangle tube?

• Faulty parts must only be replaced by genuine Triangle Tube factory parts. • To prevent damage to the inner tank, the Installer must: – Always fill inner tank prior to outer tank and always drain outer tank prior to inner tank. – Relieve primary system pressure below 15 psig prior to draining inner tank.

What to do if your triangle tube controller does not reset?

If the unit will not reset, replace the control module. Be sure to test the resistance of the gas valve, these are 120 volt gas valves and should have approximately 375 ohm resistance on one coil, and 717 ohms on a second coil. 2) If the controller resets, replace the igniter and also replace the insulation block.

If problem is not resolved, contact Triangle Tube Technical Support for additional assistance. Check to see if a sensor is far out of calibration or moving in a direction un-compatible with the process that the controller is presently running. With the unit off for at least 1 hour, go to the Info mode of the boiler. Look at steps 1, 2 and 5.

• Faulty parts must only be replaced by genuine Triangle Tube factory parts. • To prevent damage to the inner tank, the Installer must: – Always fill inner tank prior to outer tank and always drain outer tank prior to inner tank. – Relieve primary system pressure below 15 psig prior to draining inner tank.

• When receiving the SMART unit, any claims for damage or shortage in shipment must be filed immediately against the transportation company by the consignee. • Customer must register unit within sixty (60) days of installation in order to gain warranty coverage. See Warranty Card for details.

If the unit will not reset, replace the control module. Be sure to test the resistance of the gas valve, these are 120 volt gas valves and should have approximately 375 ohm resistance on one coil, and 717 ohms on a second coil. 2) If the controller resets, replace the igniter and also replace the insulation block.