What was the fuse that blew on my toilet?

It was traced to a blown 5A fuse on the habitation fuse panel (on the outside lighting circuit fuse) by the dealer. After they replaced fuse, we used the flush to fill the cassette with fresh water intermittently over 5 to 10 mins and the level indicator came on.

Why does my Thetford flush not turn on?

Turns out the Thetford flush has stopped working and the cassette level indication wasn’t working either. It was traced to a blown 5A fuse on the habitation fuse panel (on the outside lighting circuit fuse) by the dealer.

Why does the Thetford C200 CWE toilet not flush?

Thetford C200 CWE toilet will not flush? I have a Thetford C200 CWE toilet in my caravan. The van has not been used over winter, and I now find that the toilet will not flush. The 3a fuse is OK, and the 12v light in the washroom dims slightly when the toilet flush is pressed. I suspect that the pump has siezed but I do not know how to access it.

Can a blown fuse be switched back on?

The breakers reset and can be “switched back on”–so there is no need to replace anything. Much of the time, it’s technically inaccurate to refer to a “blown fuse,” so in this article, we’ll offer you some new concepts and vocabulary to describe your various electrical concerns.

It was traced to a blown 5A fuse on the habitation fuse panel (on the outside lighting circuit fuse) by the dealer. After they replaced fuse, we used the flush to fill the cassette with fresh water intermittently over 5 to 10 mins and the level indicator came on.

Why is the Thetford toilet flushing not working?

All up and running except the Thetford toilet flush not working. Checked fuse in cassette compartment, blown, new fuse fitted but blows also. Thinking that the pump might be stuck? but not sure how to access it?

How big is the fuse for a toilet flush?

I thikn you’ll find that the small two pronged fuse marked with an E is actually a 3 Amp fuse and you were looking at the number 3 upside down. Check the fuse with a continuity tester as it has been known for these blade fuses to look OK but still be open circuit. Subject: RE: Fuse for toilet flush, where is it?

What to do about fuse position on caravan toilet?

Since ‘bagging’ it its done 18 months fault-free. I note that on new Bailey models there is now a plastic shield: better late than never. ….. Also make sure area under the flush button is dry & sealed around the wire entry point to prevent damp rising & corroding the printed circuit board. Gaffer tape will be good enough.