What to use to clean a stream breaker?

Clean the stream breaker with a 50/50 solution of white vinegar and warm water. The stream breaker is the internal “grid” piece (Fig. 1). The outer solid grey plastic piece will stay in place (Fig. 2). NOTE: DO NOT REMOVE the small Philip’s head screw when pulling out the stream breaker (Fig. 3). Fig. 3

What to use to clean stream breaker on Maxton faucet?

Removal of the stream breaker may be necessary to clean any hard water build up. Clean the stream breaker with a 50/50 solution of white vinegar and warm water. The stream breaker is the internal “grid” piece (Fig. 1). The outer solid grey plastic piece will stay in place (Fig. 2).

How does a clean breaker plate work on a KCH?

Without the use of tools, the clean breaker plate is actuated into position while pushing the contaminated breaker plate out of the melt stream. Then the hydraulic puller, which is featured on all KCH models, allows the operator to pull clean screen into the melt stream in a matter of minutes.

Why does a screen changer need to be cleaned?

RESIN CONTAMINATION, DEGRADATION. The primary purpose of a screen changer is to filter out contaminants from the melt stream; but the fact is, screen changes almost inevitably introduce contaminants, some of which get into the die. These result from imperfect cleaning of the slide plate, bolt, or wheel.

Clean the stream breaker with a 50/50 solution of white vinegar and warm water. The stream breaker is the internal “grid” piece (Fig. 1). The outer solid grey plastic piece will stay in place (Fig. 2). NOTE: DO NOT REMOVE the small Philip’s head screw when pulling out the stream breaker (Fig. 3). Fig. 3

Removal of the stream breaker may be necessary to clean any hard water build up. Clean the stream breaker with a 50/50 solution of white vinegar and warm water. The stream breaker is the internal “grid” piece (Fig. 1). The outer solid grey plastic piece will stay in place (Fig. 2).

Without the use of tools, the clean breaker plate is actuated into position while pushing the contaminated breaker plate out of the melt stream. Then the hydraulic puller, which is featured on all KCH models, allows the operator to pull clean screen into the melt stream in a matter of minutes.

When to turn off electricity in a Clearstream unit?

When wastewater discharge, into a Clearstream Unit, is seasonal or intermittent to a point that the owner wishes to turn off the electricity (for more than three (3) months) to the aerator, the aerator inlet and outlet should be sealed to keep out moisture until the unit is ready to be restarted.