What to do when your status light does not blink?

If the status light does not start blinking after 90 seconds, release the gas control knob, turn the gas valve off, and wait 10 minutes before attempting to relight the pilot. On newly installed water heaters, it may take up to 2-3 lighting attempts before the pilot lights and the status light starts blinking.

What does a blinking green status light on a Waterfurnace mean?

Airflow When this light is on, it indicates either a dirty filter or an airflow problem. Clean/replace air filter. Contact your WaterFurnace dealer if problem persists. Status A blinking green STATUS light indicates that the microprocessor control, which is the “brain” of the unit, is operating properly.

What to do when your water heater pilot light goes out?

When the pilot light goes out, here’s how to light a gas water heater pilot light: Your first step is obvious: to try to re-light the water heater pilot light. First things first, try to light it again before assuming there is a major problem.

What to do if your Waterfurnace light is not flashing?

If the light doesn’t flash but remains continuously on or off, the control is inoperative. Turn off all power to the unit, including auxiliary heat, and then turn it back on. If the light remains continuously on or off, call your WaterFurnace dealer. DHW Limit A sensor monitors the temperature of the water leaving the unit.

If the status light does not start blinking after 90 seconds, release the gas control knob, turn the gas valve off, and wait 10 minutes before attempting to relight the pilot. On newly installed water heaters, it may take up to 2-3 lighting attempts before the pilot lights and the status light starts blinking.

When the pilot light goes out, here’s how to light a gas water heater pilot light: Your first step is obvious: to try to re-light the water heater pilot light. First things first, try to light it again before assuming there is a major problem.

Why is my Pool Light not turning on?

If the GFCI does not trip but the light is still not turned on, the most likely problem is a burned-out bulb. In both cases, you need to pull the fixture from the pool in order to continue your troubleshooting process.

Can you reset the water filter indicator light?

Cannot reset refrigerator water filter indicator light. 11-19-2019 01:49 PM in When the water filter indicator light turned red, it was easy to replace the water filter with a new Samsung filter. However, after pressing the area on the control panel for 3 seconds, the water filter indicator light won’t reset and is still red.