What should I do when my bathroom remodel is done?

Flush the toilet a few times to let the water drain out. Use a wet-vac to remove all excess water. Disconnect the water line. Remove the two mounting bolts at the floor and lift the toilet off the flange. Doing a retrofit or a remodel is an ideal time to address structural issues with floors, walls or ceilings.

How do you disconnect a vanity sink in a bathroom?

To disconnect a vanity sink, turn off the two shut-off valves sticking out from the wall connected to the hot and cold water supply lines. Open the faucet and let the water drain out. Disconnect the sink water lines and the drain pipe.

How do you turn off a water line in a bathroom?

Find the manifold lines near your main water supply line. Identify the line for the bathroom. Each line should be clearly marked. Use the manifold key to turn the valve on the bathroom’s line to the ‘off’ position. Pro-Tip: If you can’t turn the key, don’t force it.

How do you demolish a vanity in a bathroom?

How to Demolish a Bathroom Vanity: Put a bucket under the sink drain to catch any water in the drain trap. Use an adjustable wrench to unscrew the nuts around the u-shaped section of pipe, called the P-trap, under your sink. Dump any water caught in the P-trap into your bucket.

To disconnect a vanity sink, turn off the two shut-off valves sticking out from the wall connected to the hot and cold water supply lines. Open the faucet and let the water drain out. Disconnect the sink water lines and the drain pipe.

How do you install water lines on a vanity?

Measure and cut holes through the bottom shelf using a 1-1/4-inch spade bit and drill/driver. Cut one hole for each valve emerging from the floor. Pick up the vanity and place it over the holes, allowing the valves to slip through the holes.

How do you install a bathroom vanity at Home Depot?

Using an adjustable wrench, loosen the slip nut, or mounting nut, at the top of the P-trap (the drain pipes, named for the shape they make). Next, using the same wrench, disconnect the water supply lines.

Find the manifold lines near your main water supply line. Identify the line for the bathroom. Each line should be clearly marked. Use the manifold key to turn the valve on the bathroom’s line to the ‘off’ position. Pro-Tip: If you can’t turn the key, don’t force it.