What should I do if my pro SS InSinkErator is not working?

Reconnect the electrical power and try to run disposer. If it still isn’t working take the wrenchette that came with the disposer, or if that is missing use a ¼-inch hex wrench. On the underside of the disposer is a socket that fits the wrenchette. Place the wrenchette into the socket and turn the wrench left and right to free the grinders.

What to do if your InSinkErator garbage disposal hums?

If the grinding plate is jammed, insert an Allen wrench into this opening and turn the plate to clear the obstruction. If your disposer does not have an opening on the bottom, insert a broom handle through the top opening and wiggle the plate.

Why does my electric motor Humm and not start?

Turn off the power to the compressor. The capacitor can be tested by disconnecting them from the wiring, then with the shank of a screwdriver short the two terminals while holding on to the insulated handle. If this produces a solid discharge then the capacitor then it should be fine, but understand that it may be weak.

What to do if your InSinkErator wont drain?

After visible debris is removed and the disposer still won’t drain, try using a plunger. If the sink is a two compartment, place the sink stopper in the opposite compartment and place a large pan of water over the stopper to hold it down. Use a plunger on the disposer side to clear the drain.

What to do if your InSinkErator is not working?

Problems with your Insinkerator are usually related to it not running. Problems can be troubleshooted. Unplug the Insinkerator, or switch the Insinkerator off at the circuit breaker panel. Wait for the sink to drain, or bail the water out using a pot if the sink won’t drain.

If the grinding plate is jammed, insert an Allen wrench into this opening and turn the plate to clear the obstruction. If your disposer does not have an opening on the bottom, insert a broom handle through the top opening and wiggle the plate.

What kind of wrench do I need for InSinkErator?

Every InSinkErator is shipped with a self-service wrench. The wrench is silver colored, and shaped like a little crank, about four inches long. If you cannot find the wrench, you can use a standard 1/4-inch Allen wrench, or click here to order a replacement. Make certain that the garbage disposal’s switch is in the off position.

Can you put seafood shells in an InSinkErator?

Seafood shells shouldn’t be introduced into the disposer at all. Problems with your Insinkerator are usually related to it not running. Problems can be troubleshooted. Unplug the Insinkerator, or switch the Insinkerator off at the circuit breaker panel. Wait for the sink to drain, or bail the water out using a pot if the sink won’t drain.