What should I do if I have an f1-e9 error code?

F1-E9 – Stack Overflow – Disconnect power for at least 30 seconds and then reconnect. Allow at least a minute after power has been restored and if error code reappears, replace control board (clock).

What to do when you get a f2-e0 fault code?

F2 – E0 Shorted keypad (also called touch pad) 1. Check keypad connector for firm connection (keypad connects to control board). 2. Press CANCEL. If error code returns after 60 seconds, replace keypad (also called touch pad or membrane switch).

What to do if you get an f3-e code on your oven?

Select the ‘cancel’ function and wait 60 seconds. If error code reappears then replace the touch pad, or touch pad and control board (clock) if all one assembly. All F3-E Codes – Oven Temperature Sensor (RTD) or Warming Drawer Defect – Replace oven temperature sensor (RTD).

What to do when you get a 4 digit failure code?

4 Digit Failure Codes(for 2 digit codes see below) F1 – E0 EEPROM communication error 1. Disconnect power for at least 30 seconds. 2. Re-apply power and observe for at least one minute. 3. If code re-appears, replace control board (also called ERC or clock). Note: Applies to all F1-E… codes except F1-E3.

What to do when you get an E1 error code?

If the E1 error code shows immediately it is likely a wiring connection problem. Check the connector at the back of the display, in the handlebars and at the bottom of the right side support post. Make sure that the connectors are turned the right way, that none of the pins are bent and that they are firmly pressed together.

Why does my LG dishwasher have an E1 error code?

LG has programmed in the E1 error code to indicate when the drain pump is running, it is not receiving the back pressure it needs. This is most likely an indication that there is a water leak in the draining system. See below for what to check to fix the E1 error…. An E1 (or AE) Error Code identifies there may be a leak in your LG dishwasher.

What does the error code f2e1 mean on a stove?

The call rep said that the error code meant that the control board was malfunctioning, which was already obvious, and that the problem was solely with the control board/keypad. Check that the pressure switch is operational and replace if defective. Select the ‘cancel’ function and wait 60 seconds.

How does the E1 error code work on a treadmill?

The “Start” button is pushed and the E1 error code is displayed immediately. The “Start” button is pushed, the display count for 6 seconds, and then the E1 error code appears. The belt does not move in this situation.