What is the vacation setting on my water heater?

Vacation mode is a setting on your water heater system that allows you to run your boiler at lower temperatures than normal, saving energy. Typically, manufacturers set vacation mode to 50° F—well below the warmth you need to heat your home, but hot enough to prevent any water from freezing while you’re away.

Does my water heater have a vacation mode?

Most water heaters have a setting on their temperature dial labeled “VAC” or “VACATION.” You’ve probably seen this on the thermostat and never knew what it was used for.

Should I turn the water heater off for vacation?

It’s not recommended to completely turn off a water heater, but you can a significant amount of energy—and money—while on vacation by switching the water heater to vacation mode. If your heater doesn’t have vacation mode, simple lower the temperature several degrees to prevent it from cycling on and off so often.

How do I reset my White Rodgers Intellivent?

1 Manual reset is accomplished by first, turning off power to the water heater for 10 seconds. 2 Restore the power to the water heater. 3 Within 10 seconds of restoring power, press the two temperature adjust buttons simultaneously until the left (green) “Vacation” LED begins to blink (approx. 5 second delay).

What to do when your water heater is in vacation mode?

The unit will automatically resume heating one day before the programmed return, so that hot water will be available. If you don’t have this kind of setting, simply turn down your thermostat to the lowest setting.

How is vacation mode good for the environment?

Using Vacation Mode while you’re away from you home can be good for the environment and your wallet! Lowering the temperature of your water heater reduces your energy consumption, preserving natural resources and reducing your energy bill.

Is it cheaper to turn off hot water heater?

Turning off your hot water heater will actually cost you more than if you’d just left it on during your vacation. Sure, it costs money to keep your water hot, but it costs even more to reheat cold (or freezing) water later.

What should I do if my water heater is left on?

But, if you’ve really got your knickers in a twist about the cost of leaving your water heater on, try this. Just turn your water heater’s temperature down to the lowest setting.

Should I turn off water heater if water is off?

You should turn off your water heater if the water is off only if your water is turned off for an extended period of time, like a vacation, and you have a tank-type or hybrid water heater. For short term shutoffs, you can leave your water heater on until the cold water starts flowing in again.

What temperature should a hot water heater be set at?

When water heaters are installed, they are usually set to 140 degrees Fahrenheit. The optimal temperature setting should be 120 degrees Fahrenheit. Most likely, the water heater will be running and should shut off if you turn the thermostat down.

Where is the vacation setting on a gas water heater?

In general, if you have a standard natural gas water heater (connected to a chimney), it is very easy to switch it to “vacation” mode: just set the dial at the bottom of the appliance to VACATION. You can also shut off the cold water supply to the water heater to limit damage in the event of a leak from the tank.