What does red light on septic pump mean?

The red light indicates the alarm is receiving a signal from the pump tank that the water level is rising higher or is dropping lower than it should be. Let the septic system run a couple of pump cycles (should last about 10-15 hours) and the red light on the alarm box may go out on its own.

How do I know if my septic pump is not working?

How to Tell if Your Septic Tank Needs to be Pumped Out

1. Pooling water.
2. Slow drainage.
3. Smells.
4. Extra green grass.
5. Toilets or drains backing up.

Why would a septic tank alarm go off?

Septic tanks typically come with alarms for a good reason. The septic alarms are meant to go off when the water level in your septic system’s pump tank is either too high or too low because either condition can cause damage to the system and should be prevented.

What does a red light mean on a septic alarm?

The red light means the alarm is getting a signal from the pump tank that the water level is getting higher than it should be. Next, check the septic breaker to make sure the septic system has power.

What are the problems with a Zoeller sewage pump?

Debris under float assembly, defective switch, incoming sewage exceeds capacity of pump. Intake clogged with grease or sludge, damaged hydraulic stator or rotor, low or incorrect voltage, clogged discharge line, operating near shut-off head. Check valve stuck open or defective. Sump pit too small to handle incoming sewage.

What does it mean when a septic alarm goes off?

The green light means the alarm has power. The red light means the alarm is getting a signal from the pump tank that the water level is getting higher than it should be. Next, check the septic breaker to make sure the septic system has power.

What to do if your septic tank light goes out?

Try to use as little water as possible during this time. If the red light goes out, the system is working properly. It just needed to catch up with the additional water that was introduced into the system. If the red light is still on after 10-15 hours, contact your septic company for service.

What kind of pump does Zoeller Pump Company use?

Zoeller Pump Company’s NEW 24×24 PSF Cover & Package Systems come in both simplex and duplex configurations with a variety of sewage and grinder pump options. This short video points out some of the features and benefits of our new design.

What kind of pump do I need for my septic tank?

Effluent or dewatering submersible pumps for septic tanks, low pressure pipe (LPP) and enhanced flow STEP systems. Professional-grade, 3/10 HP submersible pump for residential dewatering (sump) or effluent (septic tank systems) use.

What to do if your Zoeller pump is clogged?

Check pump for clogging, or overload trip. Break up solids and run pump with water running into the pit. Allow level to lower to the pump intake. Continue until solids are cleared from the pit. Do not drain kitchen grease down the sink.

Where is the Zoeller Pump Company in Louisville Ky?

Although it has expanded over the years, the company still manufactures products at its original location in Louisville, KY. Even today, over 95% of Zoeller Pump Company’s branded products are made in the USA using a majority of US content.