Is the t-k3 a tankless water heater?

• If you have any problems or questions regarding this equipment, consult with Takagi or its local representative. • The T-K3/T-K3-Pro Water Heater is an on-demand, tankless water heater designed to efficiently supply endless hot water for your needs.

Where can I buy a Takagi Water Heater?

TAKAGI Industrial Co. USA, Inc. 5 Whatney Irvine, CA 92618 Toll Free: (888) 882-5244 USA Toll Free: (877) 877-4953 CANADA Flash Water Heater™ Model T-K3 and T-K3-Pro Suitable for potable water heating and space heating T-K3-Pro model ONLY – 2 – CONTENTS *40 psi or above is recommended for maximum flow

What kind of warranty does Takagi have on t-k3 pro?

PRODUCT REGISTRATION AND LIMITED WARRANTY………………… 2 3 4 5 6 6 8 9 10 11 17 19 20 21 22 23 26 27 28 28 29 29 30 31 32 35 36 38 38 38 39 40 41 44 46 47 Takagi reserves the right to discontinue, or change at any time, specifications – 3 – INTRODUCTION physical description.

What to do if your Takagi tank has hard water?

Hard Water Problems: In areas where the water is very hard with high levels of calcium and magnesium (about 7+ grains per gallon on residential application), Takagi recommends that the water be treated with a water softener or some other de-scaling device. Do not use a reverse osmosis process! It will destroy the heat exchanger.

What are the problems with a Takagi tankless water heater?

Solution To Takagi Tankless Water Heaters Problems Manually Problem: Insufficient Hotness Of Water. Possible causes and Solutions-Unit may be hard water scaled. Contact a Takagi service agent for help.-Unit may not be receiving enough gas due to improper sizing, it may be closed or the gas pressure could be too low.

• If you have any problems or questions regarding this equipment, consult with Takagi or its local representative. • The T-K3/T-K3-Pro Water Heater is an on-demand, tankless water heater designed to efficiently supply endless hot water for your needs.

How big is a Takagi t-k3 water tank?

The compact T-K3 measures under 14 inches wide, so it will fit snuggly between two wall studs to save space. But the T-K3 is also powerful.

PRODUCT REGISTRATION AND LIMITED WARRANTY………………… 2 3 4 5 6 6 8 9 10 11 17 19 20 21 22 23 26 27 28 28 29 29 30 31 32 35 36 38 38 38 39 40 41 44 46 47 Takagi reserves the right to discontinue, or change at any time, specifications – 3 – INTRODUCTION physical description.

What should the temperature be in a tankless water heater?

Increase the temperature to approximately 125-130 F, or higher if needed. Water flow might be reduced when the water filter or fixture aerator is clogged. If there is plumbing crossover, cold water is mixing with the hot water, so the outgoing water temperature is reduced.

Why does my tankless water heater take so long?

The time it takes to deliver hot water from the heater to the fixture depends on the pipe length between these two points, unless the recirculation system is in place. Due to the long water pipes, cold water that resides inside must be pushed away before hot water reaches the fixture, affecting the comfort.

What should the flow be on a t-k3 pro?

T-K3-Pro model ONLY – 2 – CONTENTS *40 psi or above is recommended for maximum flow NOTE *Check the rating plate to ensure this product matches your specifications. *In accordance with ANSI Z21.10.3 and SCAQMD Rule 1146.2, CO emission does not exceed 400 PPM for normal input or designs without notice and without incurring obligations.

How does a water heater work on a t-k3?

1. A hot water tap is turned on. 2. Water enters the heater. 3. The water flow sensor detects the water flow. 4. The computer automatically ignites the burner. 5. Water circulates through the heat exchanger and then gets hot. amount of hot water at the correct temperature.

When does a tankless water heater turn itself off?

If the water flow in your tankless water heater is too low and dips below the flow activation rate, the main gas burner will turn itself off. If your model features a standing pilot, the pilot light will not turn off – only the gas burner.

Do you get tax credit for t-k3 tankless water?

The T-K3 will meet the hot-water needs of most high volume residential applications. The purchase and installation of this energy-efficient product in your home qualifies you for the Federal Tax Credit for Consumer Energy Efficiency.

How does a Takagi tankless water heater work?

1. A hot water tap is turned on. 2. Water enters the heater. 3. The water flow sensor detects the water flow. 4. The computer automatically ignites the burner. 5. Water circulates through the heat exchanger and then gets hot. 6.

The compact T-K3 measures under 14 inches wide, so it will fit snuggly between two wall studs to save space. But the T-K3 is also powerful.

Is there a direct vent on a Takagi Water Heater?

When available combustion air is full of particulate matter enter into the heater, install a direct vent model or kit. Takagi tankless water heater with indirect vent is not ideal in places with polluted air. 7. No Ignition