How to pull start a Honda gx160 engine?

Pull start honda gx160 assembly with steel rod ratchet, bolted up in about 3 minutes and worked perfect first pull This is a new style recoil starter for Honda meaning this one has 2 metal pin coming out instead of old type of plastic dog. If your Honda engine uses this or your gas cap is the new style thick gas cap then it will be perfect.

What are the problems with a Honda water pump?

If the vacuum is low and the engine speed is correct, there is an internal problem with the pump (worn components, etc.). If the engine speed is too low, there is a problem with the engine (engine worn out, governor problem, etc.). Low discharge capacity or pressure. Excessive head loss due to restricted discharge hose or very long discharge hose.

Is the suction head on a Honda pump too big?

Static suction head too great and/or suction hose too long or too small in diameter. Always use the shortest suction hose possible. Keep the hose diameter equal to or greater than the pump’s suction port. Pump housing cracked or broken. Vehicle ran over discharge hose. Reposition and/or protect discharge hose.

What should the vacuum gauge read on a Honda water pump?

Fill the pump with water and attach a vacuum gauge to the suction port. Remove the discharge hose and start the pump. Move the throttle to fast. The gauge should read at least 20 inch Hg. If the vacuum is low and the engine speed is correct, there is an internal problem with the pump (worn components, etc.).

What to do if your Honda water pump won’t Prime?

As always, if you need Honda water pump parts contact The following is a troubleshooting guide that addresses some of the more common problems found with water pumps: Issue: After three minutes, pump won’t prime. The first step is to check whether or not the pump housing is filled with water.

Pull start honda gx160 assembly with steel rod ratchet, bolted up in about 3 minutes and worked perfect first pull This is a new style recoil starter for Honda meaning this one has 2 metal pin coming out instead of old type of plastic dog. If your Honda engine uses this or your gas cap is the new style thick gas cap then it will be perfect.

What should Hg be on Honda water pump?

Set the throttle to fast. If the pump is working properly, the gauge should read at least 20 inch Hg. If it’s lower, the internal components of the pump may be worn. If the engine is too slow, the engine could be the problem.

Static suction head too great and/or suction hose too long or too small in diameter. Always use the shortest suction hose possible. Keep the hose diameter equal to or greater than the pump’s suction port. Pump housing cracked or broken. Vehicle ran over discharge hose. Reposition and/or protect discharge hose.