How much does it cost to rebuild a shower valve?

Repair a shower valve: national average cost The national average materials cost to repair a shower valve is $50.80 per valve, with a range between $47.53 to $54.07. The total price for labor and materials per valve is $243.64, coming in between $221.88 to $265.40.

How do you repair a tub and shower valve?

Step 1: Turn off water. Turn off the water to the bathtub and shower at the shut-off valve. Let any remaining water flow out of the faucet. Step 2: Remove the cap and screw. Remove the cap and screw from the faucet handle using a screwdriver, and take off the handle and escutcheon.

How to repair a faulty shower valve stem?

This Old House plumbing and heating expert Richard Trethewey fixes a faulty shower valve with new valve stems and seats. (See below for a shopping list, tools, and steps.) 1. Turn off the water at the water main or wherever it enters the house. 2. Cover the tub/shower drain with a cloth to prevent small parts from dropping into the drainpipe. 3.

When do you need to replace a shower valve?

If your shower valve is damaged beyond repair, you may need to replace it to prevent leaks. Removing your old valve and installing a new one can take time, but with patience, a novice handyman can do it without the help of a plumber. As you replace your shower valve, work carefully to make sure you don’t forget any important details.

What’s the best way to replace a shower handle?

Remove the screws holding the handle in place and lift it off of the handle stem. Set the handle and screws on a flat surface to keep them aside until you’re ready to screw them back in later. After you have the screws out, you may need to wiggle or tap on the handle to get it to slide off the stem. Unscrew the trim plate.

Step 1: Turn off water. Turn off the water to the bathtub and shower at the shut-off valve. Let any remaining water flow out of the faucet. Step 2: Remove the cap and screw. Remove the cap and screw from the faucet handle using a screwdriver, and take off the handle and escutcheon.

How do you replace a shower faucet in a bathroom?

To gain access, cut out a section of drywall approximately a foot square on the other side of the wall from your shower valve. To locate the valve, drill a pilot hole or two from the bathroom side next to the valve with a long bit. Measure an even square on the back wall, and cut the section out with a drywall saw.

How do you repair a cartridge shower faucet at Home Depot?

Measure an even square on the back wall, and cut the section out with a drywall saw. The valve is mounted to a stringer running between the studs. Cut the copper pipe with a tubing cutter. Cut the pipe going up to the shower, as well as the hot and cold lines below.

Can a plumber replace an old shower valve?

Some plumbers will tell you a tile repair man will be needed after they replace your valve. But in many situations, your old and leaking Tub and Shower Mixer can be replaced without needing a tile repair afterwards. The following work example shows how you want this done!