How much clearance is needed for a tub drain?

The position of the tub drain will vary, depending on the size and design of the tub, and you’ll need to cut an access hole in the floor at the drain end of the tub to allow for positioning and installing the drain line. This hole should be 9 inches wide and extend at least 12 inches from the wall.

What’s the best way to install a bathtub drain?

To install a bathtub drain you should buy a bathtub drain kit. Dry fit all of the parts to you bathtub. Once you are happy with the fit, glue all of the pieces together. After that, install the new bathtub drain to your bathtub.

How long does it take to install a tub drain?

If you need to fix a faulty drain or want to upgrade your hardware, you can easily install a tub drain in about 1 hour. Foot lock stoppers are a simple type of drain mechanism that can be removed by turning them counterclockwise. For a lift-and-turn drain, loosen the center screw or turn it clockwise and twist the piece out.

Where to put drain and vent lines in a bathroom?

Drain and vent lines must be positioned precisely, so you should install them before the supply pipes. It may be possible to simplify supply runs by moving a vent pipe over a few inches.

Why do I have to hold drain lever down for tub to drain?

If you have to hold your drain lever down for the tub to drain it is more than likely the tension spring on the back of the overflow plate. You can replace just this plate at your hardware store for a few dollars.

How do you fix a tub drain?

Keeping a few items on hand allows you to fix the slow bathtub drain yourself with little work. Pour 1/2 cup baking soda into the drain, and follow up with 1 cup white vinegar. Let the ingredients combine and foam for five minutes; this deodorizes the drain and loosens mild blockage.

How do you change drain in bathtub?

Apply silicone caulk to the bottom of the new drain basket and place the drain basket inside the drain. Grasp the arms inside the drain basket with a pair of pliers and turn it clockwise to tighten it.

How do you install a bathtub drain and overflow?

How to Install a Tub Overflow Drain Step 1 – Pick the Overflow Drain Step 2 – Purchase Additional Materials Step 3 – Secure Your Permits Step 4 – Check Bathtub Access Step 5 – Cut the Hole Step 6 – Remove the Old Overflow Tub Drain Step 7 – Install New Piping Step 8 – Fill the Tub Step 9 – Close Up the Hole Note

How do you clean a tub drain?

Pour baking soda and white vinegar down your drain and scrub with a drain brush as an alternative method of cleaning the drain. Use baking soda and vinegar to clean your bathtub/shower stall, bathroom sink and toilet bowl.