How do you use a KOHLER touchless toilet?

Simply hold your hand over sensor. Our touchless technology is available pre-installed on select KOHLER® models or as an easy-to-install kit that fits most toilets. Activate the no-touch flush simply by holding your hand over the tank.

Why do automatic toilets flush randomly?

A toilet that seemingly flushes itself is a common problem that is usually caused by a slow leak from the tank to the bowl. Once the water level drops below a certain point, the float signals that the tank needs to be refilled, causing the “flushing” sound.

How does a touchless toilet work?

One of the most common touchless flush systems make use of a motion sensor located near the top of the toilet but facing out over the seat. These motion sensors make use of an infrared light that is set to trigger when you are within a certain distance.

Why does my Kohler touchless flush toilet Beep?

NOTE: The Touchless Module beeps five times before it activates, indicating low batteries. Batteries are low. Replace the batteries. Do not use rechargeable batteries. Possible Cause: When refilling, the water rises too rapidly and activates the sensor.

How to troubleshoot a Kohler toilet water supply?

1 Fully open the water supply shut-off valve. 2 Verify that the flapper or canister are properly seating after the flush. A loose chain or other object may be interfering with the refill. 3 Clean the fill valve inlet or the fill valve seat/seat washer. 4 Verify that the water supply is free of debris.

Do you use Kohler flush and fill valves?

IMPORTANT! Use only KOHLER Genuine Parts to avoid property damage and achieve optimal performance. The phrase “Standard Toilets” applies to floor-mounted toilets with standard flush and fill valves and dual flush models. Refer to In-Wall Toilet Tank Troubleshooting if you have an in-wall toilet tank.

How to fix slack in Kohler dual flushing toilet?

The troubleshooting problems in this help topic include: If you are unable to correct the problem, contact KOHLER Customer Care Center: Check the trip lever chain for excessive slack. Remove one or two chain links to remove slack, if needed. For dual flushing toilets, verify that the rod length is correct.

NOTE: The Touchless Module beeps five times before it activates, indicating low batteries. Batteries are low. Replace the batteries. Do not use rechargeable batteries. Possible Cause: When refilling, the water rises too rapidly and activates the sensor.

Who is the manufacturer of the Kohler toilet?

Kohler toilets are manufactured by Kohler which is headquartered in Wisconsin, United States. It is one of the largest toilet manufacturer in the world. Kohler was founded in 1873 by John Michael Kohler.

What should water level be on Kohler touchless flush toilet?

Raise the bracket on the Touchless Module up one notch (one number lower) on the bracket. Refer to the installation instructions. Verify that the waterline in the tank is not too high. There should be a minimum of 1/2″ (13 mm) between the water and the bottom of the Touchless Module. Lower the water level if needed.

Why do you use Kohler in your toilet tank?

Use only KOHLER Genuine Parts to avoid property damage and achieve optimal performance. The components in your toilet tank may look slightly different than those shown in the illustrations. The troubleshooting steps remain the same.