How do you tighten a toilet seat without access?

Procedures to Tighten Toilet Seat

1. Step 1: Exam the Toilet Closely One Again. For the majority of the cases, your toilet probably did have holes for underside access.
2. Step 2: Re-Align the Seat.
3. Step 3: Tighten the Bolts.
4. Step 4: Check the Tension and Close the Lid.

How do you mount a Kohler toilet tank?

Thread the mounting nuts onto the tank bolts and hand-tighten them with your fingers. Then, tighten them down slightly more with a socket wrench and 13 mm socket. The nuts should compress down into the rubber gaskets.

Can You crack the base of a Kohler toilet?

Kohler’s instructions merely state that you should not overtighten the nuts, but this should be emphasized: it is fairly easy to crack the Highline’s base if you overtighten these mounting bolts. You can avoid this by using channel-lock pliers to tighten these bolts, rather than a socket wrench.

Can you tighten a toilet seat with no access?

There is the one toilet seat that is getting tighten or installed in the back of the toilet. The easiest one to install. Then, there is the toilet seat that has no access. Meaning that there are actually no screws that you can unscrew to replace the toilet seat. This is the type of toilet seat that we are going to discuss today.

How many bolts do you need for a Kohler Highline toilet?

Some toilets come with two sets of floor mounting bolts, allowing you to choose the set that best matches your toilet flange. However, the Kohler Highline comes with just one set of fairly long bolts, so it is likely you will need to cut off the tops of the mounting bolts to allow the caps to fit over them.

There is the one toilet seat that is getting tighten or installed in the back of the toilet. The easiest one to install. Then, there is the toilet seat that has no access. Meaning that there are actually no screws that you can unscrew to replace the toilet seat. This is the type of toilet seat that we are going to discuss today.

When do you need to replace a Kohler toilet seat?

Some Kohler toilets use an attachment system for their seats called anchors. Normally these anchors do not need to be replaced when changing your toilet seat unless they have broken and the seat cannot be removed. The seat anchor kit (part number 84999) is for the removal of broken anchors and the installation of new ones.

How do you tighten an anchor on a toilet seat?

Use a 7/16 inch socket to tighten the setting bolt until the anchor is compressed (Fig. 4). Unscrew and remove the setting bolt from the anchor.

How can I Make my Toilet Seat fit better?

Realign the toilet seat, so that it fits perfectly on the toilet before you fasten the bolts again. Making sure that you make it as tight as possible without cracking the plastic of the toilet seat. Now you have tightened the toilet seat, even if the seat doesn’t have any access underside the toilet.