How do you remove handles from bathroom fixtures?

I used a 3 inch scraper blade and a hammer. I very gently tapped that thin, tapered scraper blade between the bottom of the escutcheon (the bell-like part between the handle and the sink) just enough to loosen it a bit. I then was able to unscrew (counter-clockwise) the escutcheon with the handle attached.

What kind of faucet has a plastic handle?

If you have a very old two-handle faucet, it may be a compression-type rather than a cartridge. You’ll know when you remove the faucet handle: Cartridges are usually plastic and are held in place with a metal retaining nut; compression faucets usually have a metal valve with a flat rubber washer on the bottom.

Where is the handle on a bathroom escutcheon?

I then was able to unscrew (counter-clockwise) the escutcheon with the handle attached. Note that the escutcheon is made of plastic, so be gentle. Also, the handle is screwed to the escutcheon by a screw that is located at the inside top of the escutcheon. So, pulling on the handle will not work.

Can you remove the handles from a washer?

I’m not positive this will allow you access to the washers, but from the photo those parts can be removed. The handle part of the handles are often removable, allowing you to swap out handles (between wood and chrome). However, this is usually simply to change the look of the handle, and has nothing to do with removing the handles.

How do you take a double handle shower handle off?

Remove decorative caps on the handles by placing the end of a screwdriver beneath the edge of the caps and popping them off. Turn the screws in the centers of the handles counterclockwise with the screwdriver and lift the handles off the faucet.

If you have a very old two-handle faucet, it may be a compression-type rather than a cartridge. You’ll know when you remove the faucet handle: Cartridges are usually plastic and are held in place with a metal retaining nut; compression faucets usually have a metal valve with a flat rubber washer on the bottom.

I used a 3 inch scraper blade and a hammer. I very gently tapped that thin, tapered scraper blade between the bottom of the escutcheon (the bell-like part between the handle and the sink) just enough to loosen it a bit. I then was able to unscrew (counter-clockwise) the escutcheon with the handle attached.

I then was able to unscrew (counter-clockwise) the escutcheon with the handle attached. Note that the escutcheon is made of plastic, so be gentle. Also, the handle is screwed to the escutcheon by a screw that is located at the inside top of the escutcheon. So, pulling on the handle will not work.