How do you remove a Grohe Seabury shower handle?

The Seabury is a widespread bathroom faucet with lever-style handles. To remove either handle, you simply grip it and pull upwards. If it doesn’t come off, wiggle it back and forth a bit while you pull harder. If you can’t muster enough strength to lift it, you may need to use locking pliers.

Do you need to replace the Grohe shower cartridge?

If your Grohe shower includes a thermostatic valve or pressure-balancing valve, any malfunction affecting these might also warrant replacing the shower cartridge. You’ll be removing the components that normally hold back the water in the supply pipes, so it’s imperative to turn off the water to the shower before you begin.

Where are the hex keys on a Grohe shower cartridge?

The hex key holes will be star shaped and located on either side of the shower cartridge. Turn the shower cartridge counterclockwise while pulling out of the fixture to remove it. Replace the old cartridge with your new one. Turning it clockwise to seat it into place, and using the hex keys (clockwise) to lock it tight.

Where is the shut off valve on a Grohe shower?

The shower shutoff valve is sometimes inconveniently located within your drywall. In that case, turn off the main water supply to the house before continuing with this project. Next, you’ll need to remove the decorative trim.

Where is the faceplate on a Grohe shower?

The faceplate will be located between the hot and cold water knobs and typically in the bathtub itself. For full showers it may be located higher, near the shower head itself. Always turn the hex key counter clockwise to loosen and remove the faceplate. Attach your channel locks to the shower cartridge.

Can you replace an old Grohe shower valve?

Happy to know that the compatibility remained the same over the years. Old valve had to be replaced dure to buildup of scale. 4 stars for lack of instructions and lack of lube for the rings. After installing the new valve, the shower would just be tolerable heat wise on the lowest setting (too hot).

What should the temperature be on a Grohe shower?

After installing the new valve, the shower would just be tolerable heat wise on the lowest setting (too hot). After troubleshooting, It turns out that the valve comes from the factory all the way to the hottest setting. You have to adjust the temperature and should calibrate it to 100f before installing the knob back on.

What is the Grohe pressure balance valve cartridge number?

Choosing genuine Grohe parts is your assurance that your Grohe product will continue to function as originally designed.Valve Function :Thermostatic Grohe Thermostat/Pressure Balance Valve Cartridge # 47 111 000. For Grohmix thermostat 34 434, 34 436, 34 485. Paraffin cartridge.

How to reassemble a Grohe Thermo ELEMENT cartridge?

Let them soak for a good couple of hours and then scrub with an old toothbrush or scrubby pad. Get all that lime scale off. Lube everything up with silicone grease and reassemble.