How do you change the mode on a Cal Spa hot tub?

Many Cal Spas have 3 modes. Change these settings by pressing TEMP followed by LIGHT buttons. All 3 modes will rotate.

Why is my Cal Spa not heating?

Low flow in your spa or hot tub is most commonly associated with a dirty spa filter. If your spa heater won’t heat, remove and clean the filter(s) rule out a pressure or flow rate problem. Low water level, a clogged pump impeller, closed valves, clogged pipes or blocked spa drain covers can also cause flow issues.

How to troubleshoot a problem with a Cal spa?

Troubleshooting 1 Message on the control panel. A message on the control panel may indicate a problem. 2 Problems starting up. Note: The priming procedure described here applies to Cal Spas built in 2013 and earlier. 3 Power and electrical problems. 4 Heat problems 5 Jet problems 6 Water pressure problems

When did I start priming my Cal spa pump?

Note: The priming procedure described here applies to Cal Spas built in 2013 and earlier. Beginning with the 2014 product line, Cal Spas pumps have a different method of priming. See the 2014 owner’s manual for a full description. Note: The priming procedure described here applies to Cal Spas built in 2013 and earlier.

What are the message codes on a Cal spa pump?

Beginning with the 2014 product line, Cal Spa control panels display different message codes. For a description of these message codes, see the owner’s manual. Note: The priming procedure described here applies to Cal Spas built in 2013 and earlier. Beginning with the 2014 product line, Cal Spas pumps have a different method of priming.

Do you need to measure for a Cal spa cover?

The Cover Guy custom manufacture’s all Cal Spas replacement Spa Covers. The Cover Guy has all the Cal Spa models on file so you never need to measure for your new hot tub cover! When ordering your Cal Spa replacement hot tub cover just leave the dimensions field blank.

Troubleshooting 1 Message on the control panel. A message on the control panel may indicate a problem. 2 Problems starting up. Note: The priming procedure described here applies to Cal Spas built in 2013 and earlier. 3 Power and electrical problems. 4 Heat problems 5 Jet problems 6 Water pressure problems

Beginning with the 2014 product line, Cal Spa control panels display different message codes. For a description of these message codes, see the owner’s manual. Note: The priming procedure described here applies to Cal Spas built in 2013 and earlier. Beginning with the 2014 product line, Cal Spas pumps have a different method of priming.

Note: The priming procedure described here applies to Cal Spas built in 2013 and earlier. Beginning with the 2014 product line, Cal Spas pumps have a different method of priming. See the 2014 owner’s manual for a full description. Note: The priming procedure described here applies to Cal Spas built in 2013 and earlier.

Why does my Master Spa circ pump keep running?

If the tubing from the button to the motor develops a leak while it’s on you can’t shut it off and vis-versa. Master Spas come programmed to run the circ pump 24 hours. Is this a new issue? The ‘circ pump’ is the small pump that runs the heater and has a dedicated return.