How do old bathtub drains work?

They work by a connection between the drain stopper and a lever via a rod mechanism hidden behind the bathtub. When the lever is up, the stopper is held in place, keeping your tub filled with water. When the lever is moved down, the stopper lifts and the tub drains.

Is the drain pipe too narrow for a tub?

The pipe is far too narrow for a tub, two sinks, a dishwasher and a washing machine: only 4cm. There’s a very sharp 90° bend near the exit from the property, which is where a huge blockage accumulates (10cm deep solid chunk of waste). Apparently a waste plumbing no-no. Most of the pipework lies flat on the floor, with zero slope.

Where is the stopper on a bathtub drain?

You operate this drain stopper by using a trip lever that is installed on the overflow drain on the side of the tub, just below the faucet. This lever is attached to a rod that runs through the overflow drain and connects to and controls a stopper that is inside the drain, rather than on the tub’s floor.

Is there a drain kit for an old Kohler tub?

When I told her my existing drain flange was 3 1/8 inches and that the existing drain opening was slighlty less that 2 inches, she indicated a kit would not work since they are designed for smaller tub drain openings. What to do? Re: Bathtub Drain Kit for old Kohler Tub?

Where can I buy a vintage bathtub faucet?

Scouring the internet for old bathtub faucet parts and vintage plumbing supplies can be time-consuming and stressful, so why not just replace all of your antique plumbing fixtures, faucets, and everything else with a quality brand like Randolph Morris? See below for quality bathtubs, faucets, bathroom sinks, and more from Vintage Tub & Bath!

What do you need to know about a bathtub drain?

Here are a few bathtub drain schematics and bathtub plumbing diagrams. Fairly simple drain system. If you have to hold your drain lever down for the tub to drain it is more than likely the tension spring on the back of the overflow plate. You can replace just this plate at your hardware store for a few dollars.

Why do I have to hold drain lever down for tub to drain?

If you have to hold your drain lever down for the tub to drain it is more than likely the tension spring on the back of the overflow plate. You can replace just this plate at your hardware store for a few dollars.

Where can I buy Watco bathtub drain parts?

Replacing or repairing your tub’s drain/waste assembly is a snap with bathtub drain products made by Watco, offered by your source for drain products, PlumbingSupply.com ®. Whether you need to install a new waste and overflow, or you want to update the look of your old one, we have just what you need.

Scouring the internet for old bathtub faucet parts and vintage plumbing supplies can be time-consuming and stressful, so why not just replace all of your antique plumbing fixtures, faucets, and everything else with a quality brand like Randolph Morris? See below for quality bathtubs, faucets, bathroom sinks, and more from Vintage Tub & Bath!