Does a water softener need to be level?

We recommend keeping your brine tank at least one quarter full of water softener salt at all times, and no more than four to six inches below the top of the tank for optimum efficiency. Make sure that the salt level always remains a few inches above the water level.

Are there any problems with the Kenmore water softener?

Another common concern we get calls about often is that people tell us that water is about half way up their salt tank. If you have this issue there is something wrong with your water softener. The good news is that usually if you have this issue it can be fixed easily.

What is error code 3 on Kenmore water softener?

Kenmore Error Code #3: If you are getting an Error code 3, it may be that the switch (pictured below) needs replacing. Here are the steps to replace this switch: Step 1: Unplug the unit. Step 2: Remove the lid of your softener so you can see the motor.

Why is the timer on my water softener not working?

The timer is an electronic control board that allows you to program your water softener and lights up the display. It also controls the water softening and resin filter flushing processes. If it isn’t working, it will need to be replaced. Step 1: Put on work gloves and unplug your water softener from its power source.

Where is the rotor valve on a Kenmore water softener?

You should contact a professional to do this for you. The rotor valve directs water through your water softener during the water softening cycle and while flushing the resin filter. The rotor valve seal is located on the bottom of the rotor valve.

What to do if your Kenmore water softener is not working?

If your Kenmore water softener display is showing Error Code #1, you can try the following: Step 1: Unplug your softener and then plug it back in. Step 2: Your softener will go through a test mode; it usually takes about 8 minutes to go through this. This may solve your problem.

When did Kenmore ultrasoft 400 water softener come out?

We have a Kenmore Ultrasoft 400 water softener. It was in the house 5 years ago when we bought the house. Over time, the water just isn’t really “soft” any more.

Where can I buy Kenmore water softener in Ontario?

Since Sears has closed and you can no longer take your product directly into a store for maintenance or repair, we can help. You can trust WaterSmart to service your Kenmore water softener in Southern Ontario, as we have been proudly servicing Kitchener, Waterloo, Cambridge and Guelph for 25 years.

What does error code 1 on Kenmore water softener mean?

Error code #1, meaning a valve motor failure, is one of the more common codes you will have displayed. If your Kenmore water softener display is showing Error Code #1, you can try the following: Step 1: Unplug your softener and then plug it back in.