Can a cartridge be removed from a tap?

Click to expand… I advised a fix on a tap for a colleague recently where he explained what I think is the same problem. I suggested that the shroud around the cartridge unscrewed to gain access. He insisted it was welded or one piece and the shrouds could not be removed. He showed me a picture and I was still sure the shrouds would unscrew.

What’s the best way to remove a cartridge?

Offset ring spanner, deep socket or ‘box’ spanner. Normally it’s 17mm. You’ll then need to source replacement cartridges. Seek help here for replacements. You say monobloc. Is it a monobloc with only one combined cartridge, or is it a mixer with a separate cartridge each for hot and cold? Normally as above a box spanner may work.

Can a washer be removed from a tap?

Not open for further replies. I need to replace the washer in a tap, however it is difficult to remove the cover. It looks like it is pushed on but it is a flush fit with nowhere to prise it off, as it is domed then it is also difficult to grab it to twist it. I have included photos below, if anybody can help I would appreciate it.

What’s the best way to remove a tap cover?

The top cover definitely unscrews. You just need to try harder. [email protected] Try a rubber strap wrench like a boa or something…quite cheap and work really well…I think Aldis had some in at £2.99! Hi thanks for the tips, I tried the stanley knife but no luck.

Offset ring spanner, deep socket or ‘box’ spanner. Normally it’s 17mm. You’ll then need to source replacement cartridges. Seek help here for replacements. You say monobloc. Is it a monobloc with only one combined cartridge, or is it a mixer with a separate cartridge each for hot and cold? Normally as above a box spanner may work.

Click to expand… I advised a fix on a tap for a colleague recently where he explained what I think is the same problem. I suggested that the shroud around the cartridge unscrewed to gain access. He insisted it was welded or one piece and the shrouds could not be removed. He showed me a picture and I was still sure the shrouds would unscrew.

What’s the best way to remove a Moen cartridge?

Before trying other pulling methods, however, it’s wise to douse the cartridge with white vinegar and wait for an hour or two. It safely dissolves mineral deposits that may be binding it.

What’s the best way to remove a water valve?

Unfortunately, these rubber parts often stick to the valve housing and make removing the cartridge a challenging job. Moen sells a tool that makes pulling cartridges easier, but sometimes you need more help than that. The usual procedure for removing a cartridge is to unscrew the handle, and after turning off the water, pull out a retaining clip.